Sharp AN-60KT Service Anleitung Seite 24

PG-M25X
No. Adjustment Items
21 Confirmation and
re-adjustment of
white balance
22 Confirmation of
color-related
operation
23 Confirmation of
picture-related
operation
24 Confirmation of
RGB
25 Confirmation of
off-timer operation
26 Confirmation of
thermistor opera-
tion
27 Automatic sync
operation
28 Gyro remote
controller perfor-
mance checking
29 PC card perfor-
mance checking
30 Factory settings
Adjustment Conditions
1. The adjusting conditions for each
item are as follows:
For RGB input, see Item 11
For SRGB input, see Item 13
For video input, see Item 14
For DVT input, see Item 12
1. Receive the color bar signal.
1. Receive monoscope pattern signal.
1. Receive the RGB signal.
1. Heat the thermistor by dryer.
1. Receive the phase checking pattern
signal.
1. Insert the wireless LAN card into the
PC card slot.
2. Then insert the memory card with
the test pattern images into the PC
card slot.
1. Receive the phase checking pattern
signal.
Adjustment Procedures
Confirm that there is no deviation in white
balance from that of the monitoring
equipment.
For readjustment, proceed in the order
of RGB input, video input and DTV in-
put.
1. Select L1 in the process mode.
Check the performance of color and
tint.
1. Select L2 in the process mode.
Check Picture, Brightness and Sharp-
ness.
1. Select L4 on the process mode.
Check Picture, Brightness, Red, Blue,
Clock, Phase, H-POS and V-POS.
1. Select OFF in the process mode.
Confirm that the off-timer starts with
5-minute display, counts 1 minute for
1 second, and turns off when 0 minute
is displayed.
1. Confirm that the temperature is dis-
played.
1. Confirm that Clock, Phase, H-POS
and V-POS can be automatically
adjusted in the VGA/S-VGA/XGA
mode.
Make sure the Gyro remote controller
functions as specified.
1. Make sure the image can be prop-
erly transferred.
2. Make sure the image can be prop-
erly displayed.
1. Make the following settings.
Process
adjustment
S4
2. Register the Gyro remote controller
that is shipped together.
24
Remote control
setting
Factory setting 4"