Specifications - Sharp XG-PH50X Serviceanleitung

SPECIFICATIONS

Product type
Model
Video system
Display method
DMD panel
Lens
Projection lamp
Component input (INPUT 1)/
output (OUTPUT) signal
Horizontal resolution
Component input (INPUT 2)
signal
RGB input (INPUT 1/2)/
output (OUTPUT) signal
RGB digital input signal (INPUT 3) DVI connector (24-pin), RGB (digital), 250 –1,000 mV, 50
Video input signal
(INPUT 4)
S-video input signal
(INPUT 5)
Audio input signal
Audio output signal
(AUDIO OUTPUT 1–5)
RS-232C terminal
LAN terminal
Pixel clock
Vertical frequency
Horizontal frequency
Audio output
Speaker system
Rated voltage
Input current
Rated frequency
Power consumption
Power consumption (standby)
Heat dissipation
Operating temperature
Storage temperature
Cabinet
I/R carrier frequency
Dimensions (approx.)
Weight (approx.)
Replacement parts
As a part of policy of continuous improvement, SHARP reserves the right to make design and
specification changes for product improvement without prior notice. The performance specifica-
tion figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.
Multimedia Projector
XG-PH50X (standard zoom lens attached)/XG-PH50X-NL (no lens attached)
NTSC3.58/NTSC4.43/PAL/PAL-M/PAL-N/PAL-60/SECAM/
DTV480I/DTV480P/DTV540P/DTV576I/DTV576P/DTV720P/DTV1035I/DTV1080I
Single Chip Digital Micromirror Device
Panel size: 0.7"
No. of dots: 786,432 dots (1,024 [H]
1.2 electric zoom/focus lens, F1.8–F2.0, f = 25.6–31.3 mm (standard equipment with XG-PH50X)
250 W 2
15-pin mini D-sub connector
Y: 1.0 Vp-p, sync negative, 75 Ω terminated
PB: 0.7 Vp-p, 75 Ω terminated
PR: 0.7 Vp-p, 75 Ω terminated
750 TV lines (DTV720P)
BNC connector
Y: 1.0 Vp-p, sync negative, 75 Ω terminated
PB: 0.7 Vp-p, 75 Ω terminated
PR: 0.7 Vp-p, 75 Ω terminated
15-pin mini D-sub connector, 5 BNC connector
RGB separate/sync on green type analog input: 0–0.7 Vp-p, positive, 75 Ω terminated
HORIZONTAL SYNC. SIGNAL: TTL level (positive/negative)
VERTICAL SYNC. SIGNAL: Same as above
RCA connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75 Ω terminated
4-pin mini DIN connector
Y (luminance signal): 1.0 Vp-p, sync negative, 75 Ω terminated
C (chrominance signal): Burst 0.286 Vp-p, 75 Ω terminated
ø3.5 mm stereo minijack: AUDIO, 0.5 Vrms, more than 22 kΩ
ø3.5 mm minijack
0.5 Vrms, less than 2.2 kΩ
9-pin mini DIN connector
8-pin RJ-45 modular connector
12–230 MHz
43–200 Hz
15–126 kHz
3.0 W (stereo)
4.5 cm round 2
AC 100–240 V
6.3 A (AC 100 V)–2.6 A (AC 240 V)
50/60 Hz
630 W (when "Eco Mode" is "OFF")/505 W (when "Eco
600 W (when "Eco Mode" is "OFF")/485 W (when "Eco
0.75 W (AC 100 V) – 1.25 W (AC 240 V) (When "Monitor
2,370 BTU/hour (when "Eco Mode"
2,260 BTU/hour (when "Eco Mode"
41°F to 104°F (+5°C to +40°C)
–4°F to 140°F (–20°C to +60°C)
Plastic
38 kHz
16 5 / " 7 3 / " 18 35 / " (410 (W)
32 32 64
5 37 35
16 / " 7 / " 18 / " (410 (W)
32 64 64
parts)
XG-PH50X: 32.7 lbs. (14.8 kg), XG-PH50X-NL: 30.0 lbs. (13.6 kg)
Lamp unit (AN-PH50LP1/AN-PH50LP2), Remote control (9NK5041808700), Power cord for U.S., Canada,
etc. (9NK3090152800), Power cord for Europe, except U.K. (9NK3090152700), Power cord for U.K., Hong
Kong and Singapore (9NK3090152900), Power cord for Australia, New Zealand and Oceania (9NK3090152600),
RGB cable (9NK3080431000), Remote mouse receiver (9NK3790197000), Cap for the standard zoom lens
(9NK3797200400), Projector manual and technical reference CD-ROM (9NK3532094500), Operation manual
(9NK5010011800)
TM (DMD TM ) by Texas Instruments
768 [V])
Ω (Compatible with HDCP)
Mode" is "ON") with AC 100 V
Mode" is "ON") with AC 240 V
Out" and "LAN/RS232C"
is "OFF")/1,900 BTU/hour (when "Eco
is "OFF")/1,825 BTU/hour (when "Eco
180 (H) 471 (D) mm) (main body only)
192.1 (H) 471 (D) mm) (including adjustment foot and projecting
3
XG-PH50X
XG-PH50X-NL
are set to "Disable".)
Mode" is "ON") with AC 100 V
Mode" is "ON") with AC 240 V