Sharp AN-60KT Service Anleitung Seite 15

PG-M25X
5. Removing the other PWBs
5-1. Disconnect the connectors.
5-2. Remove the four lock screws from the power PWB.
5-3. Remove the lock screw from the ballast PWB unit.
5-4. Remove the three hex support screws from the input PWB.
5-5. Remove the lock screw from the terminal block cover.
5-6. Remove the three lock screws from the PFC PWB.
5-7. Remove the one lock screws from the Gyro antenna.
5-8. Remove the three lock screws from the Gyro PWB.
5-4
Input PWB unit
5-5
5-2
5-1
PFC PWB unit
5-3
Ballast PWB unit
5-6
5-1
Power PWB unit
5-1
5-7
5-8
Bottom body
Gyro Antenna
Gyro Sub PWB unit
Gyro PWB unit
15