to trigger the corresponding response:
Button
Press and release "ON" button
Press and release "OFF" button
Press and hold down "ON" button
Press and hold down "OFF" button
8
Resetting to the initial state
To reset the actuator to the initial state, put the device
into teach-in mode using the channel button (hold it
down for at least 4 seconds). If the device is in teach-
in mode, hold the channel button down for at least 4
seconds again. If the device LED flashes quickly, this
indicates that the actuator is being reset.
9
Device LED feedback
9.1 Flashing codes
Various actuator states are indicated by the channel
LED flashing:
34
Response
ON
OFF
Dim up
Dim down