7
Operation
After teaching, simple operating functions are available using
the taught control elements. Brief press of the button: ON/OFF.
Additional long button press for dimming: Dim.
The following behavior results in this case:
Button
Brief button press "ON" button
Brief button press "OFF" button
Long button press "ON" button
Long button press "OFF" button
8
Resetting to factory status
In order to reset the actuator to factory status, switch the de-
vice to teach mode with the (first) channel button (hold button
pressed for at least 4 seconds). If the device is in teach mode,
hold the (first) channel button pressed down for at least 4 se-
conds. The actuator reset is indicated by the device LED flashing
quickly.
9
Device LED feedback messages
9.1
Flash codes
Different actuator states are indicated by the channel LED/chan-
nel LEDs flashing:
Slow flashing
Fast flashing
One long, x-short (depends on the type of
error)
Behavior
ON
OFF
Brighter
Darker
Teach mode
Reset
Error
19