Turning Your Burner Off - Extinguishing The Flame; Re-Igniting The Burner - EcoSmart XL Series Installationshandbuch

How to operate the Burner
Turning your Burner OFF
- Extinguishing the flame
1. Let it burn until the fuel is consumed. The flame will extinguish when
no fuel is left.
2. Use the lighting rod to move the circular ring to the fully OFF
position.
WARNING: Fire hazard. With either method, let burner cool for at
least 30 minutes before refueling.
XL Series:
The XL Series and XS340 have a flip lid shut-off mechanism. The lid
flips across the ignition zone which extinguishes the flame.
AB8 & AB3:
The AB Series lid is used to extinguish the flame.

Re-igniting the Burner

WARNING!
• NEVER LEAVE A FIRE UNGUARDED.
• ONLY USE BIOETHANOL IN THE BURNER.
• IGNITION OF THE LIGHTING ROD SHOULD ONLY BE
PERFORMED ABOVE AND BESIDE THE BURNER TO AVOID
DRIPPING THE FUEL AT ANY STAGE OF THE LIGHTING
PROCESS OUT OF THE FIREBOX ONTO THE FLOOR.
• THE BURNER MUST NOT BE FILLED AT ANY TIME WITH
ADDITIONAL BIOETHANOL WHEN THE FLAME IS GOING OR
WHEN THE BURNER IS HOT.
• AN INHERENT DANGER WITH BIOETHANOL IS THAT THE
FLAME PRODUCED CAN BE NEARLY INVISIBLE IN NORMAL
DAYLIGHT CONDITIONS OR WHEN FIRST LIT. BEING DIFFICULT
TO SEE, AN INEXPERIENCED PERSON CAN EASILY ASSUME
THE BURNER IS EMPTY AND NEEDS FILLING.
ASSUME BURNER IS LIT, EVEN IF YOU DON'T SEE FLAME.
FOLLOW PROCEDURE TO EXTINGUISH FLAME AND ALLOW
UNIT TO COOL BEFORE ATTEMPTING TO REFUEL. NEVER
REFUEL WITH BURNER LIT OR WHILE UNIT IS HOT.
1. Move the slider/hinge so the Burner opening is fully open.
2. Wait 30 minutes before re-igniting the Burner. The Burner should
be at room temperature. Please be aware that if this time is not
respected the ignition could be pressurised and therefore stronger. A
pressurised ignition can cause serious burns if you are close to the
Burner.
3. Re-ignite as described in "Lighting the Burner".
© Copyright 2004 - 2011 The Fire Company Pty Ltd. All rights reserved. V8 090911