Lighting The Burner; Regulating The Flame; Baffles - EcoSmart XL Series Installationshandbuch

ENGLISH
How to operate the Burner

Lighting the Burner

Keep hands and face the length of the lighting rod away from
the Burner at all times, particularly when igniting. Before lighting,
ensure that the Burner is clear and ready for use. When lighting the
Burner the slider must be positioned at MAX to allow for correct
ventilation.
Check the slider is free from obstruction and operating smoothly.
(Refer to Troubleshooting section on page 20 if difficulties are
experienced).
Do not smoke while lighting the Burner, and make sure that no one is
in front of the fireplace while igniting the Burner. Only use the lighter
supplied with your EcoSmart™ Fire.
2
1
1. Dip the lighting rod tip into the chamber opening "Burner zone" to
wet the end.
2. Lift the lighting rod away from the Burner (do not drip fuel on the floor).
3. Ignite the lighter and make contact with the lighting rod as if lighting
a candle.
4. Dip the ignited lighting rod back into the Burner zone to ignite the
contained fuel.
5. Allow residual flame on lighting rod to burn out.
NOTE: The XL900 & XL700 is best ignited from the right hand side of
the ignition zone.
Once lit there will be a residual flame on the lighting rod that must burn
out before putting the rod away. If the flame on the lighting rod dies
before reaching the burner, repeat the procedure until successful.
Due to some residual oil in the fibres we use in the Burner there is a
stronger smell when first operating. It will decrease substantially after
the first few times you use the Burner, and even more so over time. To
minimise this, wash the burner out in hot water before using. The Burner
must be completely dry and cool before filling with fuel.
www.ecosmartfire.com

Regulating the flame

Wait until the fire is established (approx 10 minutes) before regulating.
To decrease the flame intensity insert the lighting rod tip through the
circular ring and push forward gently to desired setting. Only use the
lighting rod supplied with your EcoSmart™ Fire to avoid hand burns.
To increase the flame intensity insert the lighting rod tip through the
circular ring and pull back gently to desired setting. Only use the lighting
rod supplied with your EcoSmart™ Fire to avoid hand burns.
3

Baffles

Accessories are available to regulate models that are ON/OFF
functioning only - these baffles are inserted into the burner opening
when cold and not operating - this increases the efficiency of the
burner as well as decreases the output of the burner. Contact your
local retailer/distributor or head office.
Note: Regulatory function and accessories not applicable to BK2UL or
AB3 - in these models, the control must be in the fully ON or fully OFF
4
position only. The flame cannot be adjusted.
XL900 4 x Baffles
XL500 2 x Baffles
Important: All Burner parts will age over the course of time through
natural processes associated with use, heat and flame.
Please also note that new stainless steel has an oil coating that will burn
off during the first few uses. You will notice an accumulation of carbon
around the top opening of the Burner zone and its vents. This will appear
quickly and is normal. You will need to perform your first maintenance
after approximately 20 litres [5.28 Gal] of Bioethanol burnt.
After this, the accumulation will be far slower and maintenance can
then occur every 50 litres [13.20 Gal] of Bioethanol burnt. If anything
abnormal appears, do not operate the unit. If the fire is running, turn it off
immediately and contact your distributor before using again.
XL700 3 x Baffles
SCALE 1:10