Decanting The Fuel From The Jerry Can Into The Burner - EcoSmart XL Series Installationshandbuch

How to operate the Burner

Decanting the fuel from the jerry can into the Burner.

WARNING: Fire hazard. Be sure burner is cool before filling. Let stand
at least 30 minutes after flame is extinguished before refilling.
WARNING: Refuel only through the filling point. Never pour fuel
directly onto the burner.
WARNING: Fire hazard. Do not overfill. Fill only to MAX mark. Never
lift the jerry can to allow faster flow - insert the spout fully and rest
it on the base of the grid. Used properly, the jerry can spout will help
prevent over-filling and spillage.
As an additional safety measure, we recommend that you remove the
burner and check that there is no unexpected fuel collection in the Top Tray.
The Fire Company Pty Ltd recommends that the quantity of Bioethanol
poured into the burner be burnt until empty rather than extinguishing
the fire early. Extinguishing the fire early can result in a larger amount of
residual fumes in the Burner and a more volatile re-ignition.
When fumes are combined with excess fuel it could be a hazard to
people who are unaware of the Fire operation and its condition of use (e.g
smokers). Ensure only those who have read the instructions attempt to
operate the burner.
2
1
3
1. Remove the transport locking
strip and position the slider
mechanism setting so the
chamber is fully open.
2. Inspect inside the burner
mouth to ensure it is clean and
clear of any foreign particles.
3. Access the filling point by
flipping the small lid which is
located in the bottom right
corner of the burner.
XL Series:
The XL Series feature a spring
loading cap. It is engineered so
that the jerry can spout is fully
enclosed prior to releasing the
fuel supply, thus allowing filling
at a high rate, whilst eliminating
splashing as the fuel is being
decanted.
The XL flame is most visible
when the burner is filled to the
MAX line.
AB8 & AB3:
To fill the AB Series, position the
jerry can spout in the middle of
the burner mouth.
4
5
8
7
9
© Copyright 2004 - 2011 The Fire Company Pty Ltd. All rights reserved. V8 090911
4. Re-position the Burner slider
ensuring the grid work of
the burner is visible through
the filling point. This will
clear the filling point for the
insertion of the jerry can spout
as well as allowing visual
monitoring of the amount of
fuel being added, according
to the volume markings on the
Burner.
5. Once ready, carefully place
the jerry can spout inside the
filling point. NEVER fill over the
maximum level as indicated
on the burner vent inside the
Burner and only fill to the level
that you require for burning
time.
6. Use both hands to pour. Place
the palm of one hand on the
top of the nozzle with your
thumb on the green button.
Use your other hand to tip
the can vertically and hold it
steady. Press down on the
green button to release the
fuel. To stop the flow, simply
release the green button.
7. When filling is complete, flip
the lid that covers the filling
point so it closes the filling
point.
8. Re-position the slider to the
fully open position. Check
surrounding area for any
spillage. WARNING: Fire
hazard. Clean up any spilled
fuel before lighting the
burner. See Troubleshooting
page 20 for clean-up
procedure.
9. Make sure that the jerry can is
at least 1500mm [59.1in] away
from the fireplace before you
ignite the fire.