Starting A Washing Programme; Unloading The Dishwasher - Klarstein 10027045 Bedienungsanleitung

Starting a Washing Programme

1. Draw out the lower and upper basket, load the dishes and push them back. It is recommended
to load the lower basket fi rst, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. Make sure that the water supply is turned on to full pressure.
4. With a little force to ensure the door is properly closed and press the Power button.
5. Press the Program button to select a desired wash cycle. Then press the Start button.
Change the Programme
A cycle that is underway can only be modifi ed if it has only been running for a short time. Otherwi-
se, the detergent may have already been released, and the appliance may have already drained the
wash water. If this is the case, the detergent dispenser must be refi lled
• Press Power button to cancel the programme, and turn on it again.
• Then you can change the programme to the desired cycle setting.
• If you open the door when washing, the machine pauses and warning alarm rings, the display ap-
pears E1. When you close the door, the machine will keep on working.
• The 6 programme lights show the state of the dishwasher. If one of the programme lights is on,
the cycle is running. If one of the programme lights is blinking, the cycle is paused.
ATTENTION
If If all the lights begin to glimmer, that indicates the machine is out of order, please turn
off the main power and water supply before calling a service.
Forget to Add Dish
• A forgotten dish can be added any time before the detergent cup opens.
• Open the door a little to stop the washing.
• After the spray arms stop working, you can open the door completely.
• Add forgotten dishes.
• Close the door, the dishwasher will work after ten seconds.
WARNING
It is dangerous to open the door when washing, because the hot water may scald you.
Open the door carefully!
Switch Off the Dishwasher
• The digital display appears „---" and the buzzer rings 6 times, only in this case the programme
has ended.
• Switch off the dishwasher by pressing the Power button.
• Turn off the water tap.
• Open the door carefully. Hot steam may escape when the door is opened!
• Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
• Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In
this way they will be cooler and the drying will be improved.

Unloading the dishwasher

• It is normal that the dishwasher is wet inside.
• Empty the lower basket fi rst and then the upper one. This will avoid water dripping from the upper
• basket onto the dishes in the lower one.
34