Prior Using For The First Time - Klarstein 10027045 Bedienungsanleitung

Water outlet
Connect the water drain hose. The drain hose must be correctly fi tted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
How to drain excess water from hoses
If the sink is 1000 mm higher from the fl oor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or a suitable
container that is held outside and lower than the sink.
Extension hose
If you need a drain hose extension, observe to use a similar drain hose. It must be no longer than 4
metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon connection
The waste connection must be at a height of between 50cm (minimum) and 100cm (maximum)
from the bottom of the dish. The water drain hose should be fi xed by a hose clip.
When starting the dishwasher you should check:
• Whether the dishwasher is level and fi xed and the inlet valve is opened.
• Whether there is leakage at the connections of the conducts.
• Whether the wires are tightly connected and the power is switched on.
• Whether the inlet and drain hoses are knotted.
• All packing materials and printings should be taken out from the dishwasher.
Adjusting water softener
The water softener must be set manually, using the water hardness dial. The water softener is desi-
gned to remove minerals and salts from the water, which would have a detrimental or adverse effect
on the operation of the appliance. The higher the content of these minerals and salts, the harder the
water is. According to your type of dishwasher, the softener is set by dial or display. If your appliance
has no water softener, you may skip this section.
IThe dishwasher is designed to allow for adjusting the amount of salt consumed based on the
hardness of the water used. This is intended to optimize and customize the level of salt
consumption so that the salt consumption could be set proceed as follows:
Item number 10027045 (60 cm)
1. Unscrew the cap from the salt container
2. There is a ring on the container with an arrow on it (see fi gure)
3. If necessary, rotate the ring in the anticlockwise direction from the „-" setting towards the „+"
sign, based on the hardness of the water being used.
4. It is recommended that adjustments should be made in accordance with the following schema:
Hardness (°dH)
0-7
7-14
14-20
>20
25

Prior Using for the First Time

Range Position
soft (1) /
medium (2) -
hard (3) Mid
very hard (4) +