Starting A Washing Programme - Klarstein 10030930 Bedienungsanleitung

1. Draw out the lower and upper basket, load the dishes and push them back. It is recommended to load the
lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. Make sure that the water supply is turned on to full pressure.
4. With a little force to ensure the door is properly closed and press the Power button.
5. Press the Program button to select a desired wash cycle. Then press the Start button.
Change the Programme
A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the de-
tergent may have already been released, and the appliance may have already drained the wash water. If this is
the case, the detergent dispenser must be refilled
• Press Power button to cancel the programme, and turn on it again.
• Then you can change the programme to the desired cycle setting.
• If you open the door when washing, the machine pauses and warning alarm rings, the display appears E1.
When you close the door, the machine will keep on working.
• The 6 programme lights show the state of the dishwasher. If one of the programme lights is on, the cycle is
running. If one of the programme lights is blinking, the cycle is paused.
ATTENTION: If If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.
Forget to Add Dish
• A forgotten dish can be added any time before the detergent cup opens.
• Open the door a little to stop the washing.
• After the spray arms stop working, you can open the door completely.
• Add forgotten dishes.
• Close the door, the dishwasher will work after ten seconds.
WARNING
Risk of burns! It is dangerous to open the door when washing, because the hot water may scald
you. Open the door carefully!

Starting a Washing Programme

39