Switch On Stb; Standby Mode - Digital Box IMPERIAL DB 2 basic Bedienungsanleitung

2. BASIC OPERATIONS
2. 1

Switch on STB

Switch the [Device's Main Power] switch on.
When the STB is first used it will display "Quick Setup" window. you will set Language, First
Audio, Second Audio, LNB Power, Antenna Setup and Multi Search.
? Frequently Asked Question
Q: The power of my STB is on and it is running in TV mode but the TV screen shows
nothing:
A: Make sure the TV set has been set to the correct video input (not the TV channels). For
example, if you have connected the unit to the video1 input of the TV set then you need
to select the corresponding input of the TV. Mostly it is done with the AV button of the
TVs remote control unit.
Q: My STB is running in TV mode but the TV screen shows nothing except one ball and
"No Signal".
A: That means the channel you selected has no signal. This can be caused by several
reasons:
1. The channel you selected is not from the satellite to which your dish is pointing.
Select another channel.
2. The signal of current TV channel is too weak. You can try to change to other chan-
nels with a stronger signal. If the problems still exist, please consult your local dealer
or installer for technical service.
3. You selected the wrong LNB type in the installation menu or your DiSEqC switch
configuration is not correct.
2.2

Standby Mode

1. Press [Power] button to switch from TV/radio mode to standby mode
2. In standby mode press [Power] button again to switch back to TV/radio mode. The last
active channel will be showed.
3. To switch off the STB complete press the main power button.
9 DVB-S Receiver
GB