Power Setting - Digital Box IMPERIAL DB 2 basic Bedienungsanleitung

5. SYSTEM SETUP
5.6

Power setting

• Here you can set the power output to the
LNB. If your receiver is connected to the
LNB directly then you need to set the LNB
Power to "On". If your receiver is connected
to a multi switch (SMATV signal distribu-
tion system) then it may be that you don't
need to provide the power to the LNB.
But since this is depending on the kind of
installed distribution system we
recommend you to contact your installer or to refer to the user manual of this system
to get the correct information.
• You also just can change this setting and check if you still can receive the channels.
If the LNB Power is off and you still can see all channels then we recommend this
setting in order to save energy.
5.7 RCU Position Switch
When many receivers are working at the
same time, In order to prevent the other re-
ceivers to be disturbed when operating the
current receiver, here you can switch RCU po-
sition, it has three items: Position 1, Position
2 and Position 3, default position is Position 1.
41 DVB-S Receiver
GB