ABB 6010-500 Betriebsanleitung Seite 16

Operation
Setting the address range
• Switch-over:
Switching and dimming
Point the IR hand-held transmitter towards the IR
receiver(s) it is wished to control. The transmit pilot
lamp of the IR hand-held transmitter flashes during
transmit mode.
The switching functions ON/OFF act only after a short
time delay.
• Switching ON: Press key "ON" for the desired
• Switching OFF: Press key "OFF" for the desired
• Brighter:
• Darker:
Slide switch
- to left: Addresses 1 - 5
- to right: Addresses 6 - 10
address:
- IR switches are switched on
- In case of IR dimmers, the last-
set brightness level is set again
address:
- IR switches are switched off
- In case of IR dimmers, the last-
set brightness level is remem-
bered and switched off
Keep key "ON" depressed for the
desired address:
- IR switches are switched on
- In case of IR dimmers, the current
brightness level is increased
gradually as long as the key is
kept depressed
Keep key "OFF" depressed for the
desired address:
- IR switches remain switched on
- In the case of IR dimmers, the
current brightness level is reduced
gradually as long as the key is kept
depressed
GB