Herunterladen Inhalt Inhalt Diese Seite drucken

3M Jupiter Bedienungsanleitung Seite 6

Vorschau ausblenden Andere Handbücher für Jupiter:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 17
Use in the 'power-off' state is not normal, little or no protection is provided and a build up of carbon dioxide and depletion
of oxygen within the headtop may occur, vacate the contaminated area immediately.
1. Take care to prevent the breathing tube from becoming looped around protruding objects.
2. If during use the airflow into the headtop stops, is reduced and the alarm sounds or if odour is detected, vacate the contaminated
area immediately and investigate the cause (please see fault finding).
3. The 'in-use' life of the product will vary with frequency and conditions of use.
4. In everyday use, it is recommended that the product is discarded after approximately 5 years service, provided the product is
stored as stated below. Some extreme conditions may result in deterioration over a shorter period.
Doffing
Do not remove the headtop or turn off the air filter unit until you have vacated the contaminated area.
1. Lift the headtop off the head.
2. Turn off the air filter unit.
3. Unbuckle the waistbelt.
NOTE:
If the respirator has been used in an area that has caused it to become contaminated with a substance requiring special
decontamination procedures it should be placed in a suitable container and sealed until it can be decontaminated.
CLEANING INSTRUCTIONS
• Use a clean cloth dampened with a mild solution of water and liquid household soap.
• Do not use petrol, chlorinated degreasing fluids (such as trichloroethylene), organic solvents or abrasive cleaning agents to clean
any part of the equipment.
• To disinfect, use 3M 105 wipes as detailed in Reference leaflet.
MAINTENANCE
Please see Fig. 8.
Maintenance, servicing and repair must only be carried out by properly trained personnel.
Use of unapproved parts or unauthorised modification could result in danger to life or health and can invalidate any warranty.
WHAT
Airflow check
General Inspection
Calibration
Cleaning
Replace the battery pack after 500 charges
Filter gasket replacement (see Fig. 9)
If disposal of parts is required this should be undertaken in accordance with local health and safety, and environmental regulations.
FAULT FINDING
WARNINGS
DISPLAY
LOW BATTERY
LOW FLOW
LOW FLOW AND BATTERY
FLOW RECOVERY
ODOUR DETECTED
Key
= Slow Flash
= One Short Beep
PLEASE NOTE:
SYSTEM WILL SHUT DOWN BEYOND LOW BATTERY WARNING TO PROTECT CELLS FROM DAMAGE.
WHEN
Before use
Before use
Monthly if not in regular use
Before first use then monthly
After use
SOUNDER
COMMENTS
Charge Battery (Fig 1)
Hose blocked – Clear / Replace hose
Filters blocked – Replace filters (Fig 5)
Calibration incorrect – Re-calibrate (Fig 3)
See above
Normal operation
Replace filters (Fig 5)
= Long Intermittent Beep
7
STORAGE AND TRANSPORTATION
1. The equipment should be stored in the packaging provided in dry, clean conditions away from direct sunlight, sources of high
temperature, petrol and solvent vapours.
2. Do not store outside the temperature range - 10°C to +50°C or with humidity above 90%.
3. When stored as stated, the expected shelf life of the product is 5 years from date of manufacture.
4. The original packaging is suitable for transporting the product throughout the European Economic Community.
TECHNICAL SPECIFICATIONS
(Unless otherwise stated in the Reference leaflet)
Respiratory Protection
EN12941- For Nominal Protection Factor and Assigned Protection Factor please see headtop user instruction.
Outlet Flow Characteristics
Manufacturers Minimum Design Flow (MMDF) 150 l/min
Maximum flow 230 l/min.
Battery Packs
4 hr battery = 5.2V NiMH rechargeable
8 hr battery = 5.2V NiMH rechargeable
I.S. battery = 7.8V NiMH rechargeable
Intrinsic Safety
EN50020 EEx ib IIB T3, SIRA 01ATEX2076X
ib – incapable of causing ignition in normal operation
IIB – gas sub group: (EN 50014)
T3 – Max. surface temperature 200°C
ATEX2076 - Certification number
X - The battery must be charged in a safe area
Ingress Protection code EN60529 IP53
5 = Dust protection
3 = Spraying water
Operating Conditions
- 5°C to +40°C and <90% humidity
Weight (including 4 hr battery but excluding belt and filters)
Jupiter™ Air Filter unit = 815 grams
8

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis