Shutting Down; Transport; Storage; Maintenance And Care - Kärcher BDS 33/190 C Bedienungsanleitung

Apply the detergent solution to the floor
or use the dosing lever of the detergent
tank (option).
Move the appliance over the surface to
be cleaned.
Repeat process for severe contamination.
Afterwards, pick up the wastewater with
a wet vacuum or a cloth.
Adjust the speed (BDS 43/Duo C)
Caution
Risk of injury, risk of damage. The speed
switch may only be used while the appli-
ance is idle.
Turn off the appliance.
Select the desired speed via the speed
switch:
Position I = 150 U/min
Position II = 300 U/min

Shutting down

Disconnect the mains plug from the
socket.
Pull the lever for level adjustment and
bring the handle in a vertical position.
Remove the detergent tank (option) and
dispose of unused detergent solution.
Swivel the top cable hook downward.
Coil the mains cable as shown.
Swivel the top cable hook upward.
16
Cleaning
Rinse the detergent tank (option) with
clear water.
Place the appliance into the parking po-
sition.
Remove the driver plate / disc brush.
Clean the casing with a damp cloth.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
Swivel the handle vertically and lock it.
Tilt the appliance backwards into the
transport position and drive it to its des-
tination location.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
Place the appliance into the parking po-
sition.
Store the appliance in a dry room, frost-
protected room.

Maintenance and care

Rinse contaminated disc brushes with
water.
Wash contaminated pads at a max.
temperature of 60 °C.
Clean the casing with a damp cloth.
Check the mains connection cable for
damages.
– 5
EN

Transport

Storage