Shutting Down; Transport; Storage; Care And Maintenance - Kärcher BDS 43/180 C Originalbetriebsanleitung

 Release the switch to interrupt opera-
tion.
Control the direction
– Left: Press the handle downward.
– Right: Raise the handle.
 Apply the detergent solution to the floor
or use the dosing lever of the detergent
tank (option).
 Move the appliance over the surface to
be cleaned.
 Repeat process for severe contamina-
tion.
 Afterwards, pick up the wastewater with
a wet vacuum or a cloth.

Shutting down

 Disconnect the mains plug from the
socket.
 Loosen the clamps of the level adjust-
ment.
 Move the handle into a vertical posi-
tion.
 Tighten the clamps of the level adjust-
ment.
 Remove the detergent tank (option) and
dispose of unused detergent solution.
12
Cleaning
 Coil the mains cable as shown.
 Rinse the detergent tank (option) with
clear water.
 Place the appliance into the parking po-
sition.
 Remove the driver plate / disc brush.
 Clean the casing with a damp cloth.
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
 Loosen the clamps of the level adjust-
ment.
 Move the handle into a vertical posi-
tion.
 Tighten the clamps of the level adjust-
ment.
 Tilt the appliance backwards into the
transport position and drive it to its des-
tination location.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.
 Place the appliance into the parking po-
sition.
 Store the appliance in a dry room, frost-
protected room.

Care and maintenance

DANGER
Risk of injury. Pull the plug from the mains
before carrying out any tasks on the appli-
ance.
 Rinse contaminated disc brushes with
water.
 Wash contaminated pads at a max.
temperature of 60 °C.
 Clean the casing with a damp cloth.
 Check the mains connection cable for
damages.
– 4
EN

Transport

Storage