Intended Use - EINHELL BT-LS 65 U Originalbetriebsanleitung

Anleitung_BT_LS_65_U_SPK1:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout and items supplied (Fig. 1-3)
1. Splitter
2. Trunk guide
3. Trunk pusher
4. Ventilation screw
5. Hand guard
6. Motor circuit breaker switch
7. Motor
8. Cross strut
9. Foot, front - right
10. Foot, front - left
11. Connecting strut front
12. Connecting strut, rear
13. Foot, rear - left
14. Foot, rear - right
15. Motor support plate
16. Wheels
17. Axle bolt for wheels
18. Securing split pins for wheels
19. 4 x screw M10 x 60
20. 4 x spring washer M 10
21. 4 x washer M 10
22. 2 x screw M6 x 60
23. 2 x screw M6 x 40
24. 4 x washer M6
25. 2 x self-locking nut M6
26. 2 x screw M8 x 50
25.08.2011 13:43 Uhr Seite 13
27. 2 x spring washer M8
28. 2 x washer M8

3. Intended use

The wood splitter is designed for splitting wood with a
maximum length of 520 mm and a diameter of 50 to
250 mm.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Technical data
Voltage:
Power rating:
Idle speed:
Insulation class:
Protection type:
Max. splitting force:
Splitting lift:
Splitting speed:
Trunk holding capacity:
Diameter:
Max. length:
Oil quantity:
Weight:
L noise level:
pA
K uncertainty
pA
5. Before putting the equipment into
operation (see Figures 4-9)
Important. Never use the equipment if it is not fully
assembled.
Before fixing the motor support plate (15), the plate
must be pretensioned against the motor using the
GB
230 V 50 Hz
1500 W S2 20 min
2950 rpm
B
IP 54
5.5 t
390 mm
0.035 m/sec
50 - 250 mm
520 mm
3.2 l
48 kg
65 dB(A)
1,5 dB
13