Backlight; Manufacturing Reset; Firmware-Update - Elinchrom Transmitter PRO Gebrauchsanleitung

User Manual
KEY CLICK
When activated, pressing any control button will be indicated by a beep tone.
SLEEP
When not used for a time, the Transmitter Pro will switch to Sleep Mode to save battery power.
Delay Sleep mode from 1 to 60 minutes or turn OFF.
AUTO OFF
EN
The Transmitter Pro will automatically turn OFF when left unattended for a time.
Delay Auto Off start from 1 to 60 minutes or turn OFF.
When Sleep mode and Auto Off are both active, the Transmitter Pro will switch the power OFF at the user set
Sleep Mode delay.
CONTRAST
The display contrast can be adjusted from 80 to 120%

BACKLIGHT

The display illumination of the device can be switched on/off

MANUFACTURING RESET

Pressing and holding in the left and right Speed buttons approximately 2 seconds, whilst the Transmitter
is switched on, will reset the Transmitter Pro to manufacture settings. All user settings, except the display
contrast, will be reset.
FIRMWARE UPDATE
To update the Firmware of the Transmitter Pro, the Elinchrom Updater is required.
Available from the Elinchrom website.
** Not supported by Nikon .
®
*** Not supported by Sony and Olympus / Panasonic .
® ® ®
16