Elinchrom Ttl - Elinchrom Transmitter PRO Gebrauchsanleitung

ELINCHROM TTL

Get the perfect shot right from the start.
WHAT IS REQUIRED:
• The Elinchrom Transmitter Pro (Includes the TTL mode. Nikon and Canon are available, more brands will
follow).
• Elinchrom TTL flash unit (ELB 500 TTL)
• A compatible camera (The compatible cameras are listed at: http://www.elinchrom.com/support/
ELINCHROM TRANSMITTER PRO TTL FEATURES
• Groups: All or 1 to 4 can be selected individually by pressing the Group button.
• Groups on/off: All or Group 1 to 4 can be selected individually by pressing the Group button, to switch the
selected Group on/off use the speed button middle/left.
• EV value: The EV can be adjusted from -3 to +3 in 1/3 f-stops with the rotation ring. All or individual
Groups can be selected with the Group button to adjust the EV value.
• Modelling lamp on/off: The modelling lamp can be switched on/off with the speed button middle/right. All
or individual Groups can be selected with the Group button.
• For further options and settings please read the user manual of the Elinchrom TTL flash unit.
• TTL values are saved while switching to "Manual" mode.
ON/OFF
Press and hold for min. 2 seconds to switch the Elinchrom Transmitter Pro On/Off.
GROUP BUTTON
TTL / Manual Mode: Press to toggle between 1 through 4 Groups and "ALL."
TEST BUTTON (WITH EL LOGO)
Pressing the TEST button will fire all flashes when "ALL" is selected or any single Group, 1 through 4 is
selected. Please remember , if flashes should be triggered in just one selected Group, the photocell must be
deactivated.
REFRESH BUTTON
Press the Refresh button any time power setting has been done on a separate EL flash unit to update the
power setting display of the Transmitter Pro.
If a Group is selected, only the information for that selected Group will refresh.
When "ALL" is selected, information for all Groups will be refreshed.
User Manual
EN
13