Device Elements; Start Up; Dry Vacuum Cleaning; Operation - Kärcher Xpert NT 360 Bedienungsanleitung

Device elements

1 Electrodes
2 Suction hose
3 Cable hook
4 Handle for filter cleaning
5 Suction head lock
6 Wheel
7 Suction head
8 Steering roller
9 Dirt receptacle
10 Suction support
11 Floor nozzle
12 Suction tube
13 Main switch
14 Carrying handle
15 Filter cover
16 Bender
17 Flat fold filter
18 Exhaust filter
19 Floor nozzle holder
20 Power cord
21 Holder for crevice nozzle
22 Holder for suction pipes
23 Nameplate
Caution
The flat pleated filter must always be in
place while vacuuming.

Dry vacuum cleaning

When vacuuming fine dust, you may
–
also use an additional paper filter bag or
a membrane filter (special accessory).
Inserting the paper filter bag
Illustration
 Release and remove the suction head.
 Insert the paper filter bag or the mem-
brane filter (special attachment).
 Insert and lock the suction head.
12

Start up

Wet vacuum cleaning
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
If the appliance is used to vacuum wet
–
dirt the paper filter bag or the mem-
brane filter (special accessory) must al-
ways be removed.
It is recommended to use a special filter
–
bag (wet) (see Filter systems).
General
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After the wet vacuuming: Clean the flat
–
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
Turning on the Appliance
 Plug in the main plug.
 Switch on the appliance at the main
switch.
– 2
EN

Operation