General Cd Receiver Functions; Selecting The Source; Reset To Default Settings - Omnitronic EIO3-50III Bedienungsanleitung

7.2 General CD receiver functions

Put the receiving antenna in a vertical position and switch on the CD receiver with the button

7.2.1 Selecting the source

After switching on, the unit is in tuner mode. The button MODE allows switching over to another source.
Press the button so many times until the desired source is indicated in the display: Tuner, CD, USB, CARD,
or AUX. With CD, USB, and CARD, the playback of the first title on the data carrier selected will start.
*The sources CD, USB, and CARD can only be selected if they are ready or inserted.
7.2.2 Volume and tone adjustments
1. Turn the rotary press control VOL/SEL, to adjust the volume.
2. Press the rotary press control VOL/SEL, to call the menu items for tone adjustment. Press the control so
many times until the desired menu item is indicated in the display: BAS (low frequencies), TREB (high
frequencies), BAL (left/right level balance). Turn the control to set the desired value. By long actuation of
the control, you exit the menu. The setting procedure will also be stopped if the control is not actuated for
5 seconds.
*The low and high frequencies can only be adjusted when the equalizer setting Cust (custom) was
selected with the button LOUD.
5. By long actuation of the button LOUD, the loudness function can be switched on. The function boosts
low and high frequencies to produce a well-balanced sound during low volume.
6. Shortly press the button LOUD, to call the equalizer menu. To select an equalizer setting, press the
button so many times until the desired menu item is indicated in the display: Pop, Classic, Rock M, Cust
(Custom).
7. For muting the sound, press the button MUTE (indication MUTE is flashing). To switch on the sound
again, press the button MUTE once again.
7.2.3 Clock indication
1. Actuate the button CLK for shortly switching the display to clock indication.
2. During the clock indication, the adjusting mode for the clock can be activated by long actuation of the
button CLK (the hours are flashing). Turn the rotary press control VOL/SEL, to adjust the hours. Switch
to minutes with the button CLK (the minutes are flashing) and adjust the value with the rotary press
control VOL/SEL. Press the rotary press control VOL/SEL, to exit the adjusting mode. The setting
procedure will also be stopped if the control is not actuated for 5 seconds.

7.2.4 Reset to default settings

If the unit fails to operated properly, press the button REST. All personal settings will be deleted and the unit
returns to factory settings.
32/36
.
00050722.DOC, Version 1.0