Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
INSTALLING BATTERIES
Open the battery compartment cover, pressing the
projection between [
] and [
bottom of the main unit.
Install four "AA" type batteries into the
compartment.
Make sure that the polarities correspond to the (+)
and (–) marks inside the battery compartment.
Batteries can be easily installed or removed as
their (-) ends are pushed against the spring.
You may use nickel hydride rechargeable batteries.
NOTE: These batteries cannot be charged with this product. Use the designated battery charger. Also, for details
regarding use of rechargeable batteries, follow the directions accompanying them.
You will hear a beep as the batteries are installed.
NOTE: The beep will not sound if AC adaptor is connected.
Close the battery compartment cover.
Do not force the battery cover into position. Insert two tabs to the main unit first, Fig.1).
Then close the cover, pressing [
] section Fig.2). Close the cover completely Fig.3).
1)
2)
two tabs
] at the
AA (LR6)
BATTERIES
3)
PRESS
Battery symbol [
be made while the symbol is displayed. Replace the batteries. All four batteries need
to be replaced with new ones; do not mix new and old batteries or different
batteries.
The symbol might appear only during measurement although you can review readings
in memory. This is because more battery power is required for conducting a
measurement, e.g. inflating the cuff, than displaying the readings in memory. Please
have the batteries replaced.
The enclosed batteries are for monitoring, and their life may be shorter than that of
commercial batteries.
2
ADJUST DATE AND TIME AND ACTIVATE THE CLOCK
Touch "SET" KEY and keep your finger touched
to the key until "20 11" starts flashing.
Clock is set in the order of year, month, day, hour
and minute.
The flashing number increases with MEMORY
KEY [1] and decreases with KEY [2]. The
number will be fast-forwarded if you keep your
finger on the key. Touching "SET" key will fix
click!
the number and the next article will flash.
Touching "START/STOP" key will terminate the
setting.
As the date and time are set, clock is activated.
Display of the clock while the device is turned off
indicates that the clock is activated.
-7-
] will flash when battery power is low. Measurement can not
Keep your finger
on the key.
confirm
1
2
increase
decrease
Werbung
Inhaltsverzeichnis
