Installing Batteries - Nissei DSK-1011 Bedienungsanleitung

P R E P A R A T I O N B E F O R E U S E
Install batteries and activate the clock before use. Measurement can be made with clock
being inactivated. However, activate the clock to save measurement date and time with
readings for better review. The clock is inactivated as the batteries are removed.
The product can be also operated with A adaptor. See page 8.
1

INSTALLING BATTERIES

Open the battery compartment cover, pressing
the projection between ] and [
the bottom of the main unit.
Install four "AA" type batteries into the
compartment.
Make sure that the polarities correspond to the
and marks inside the battery compartment.
Batteries can be easily installed or removed as
their - ends are pushed against the spring.
You may use nickel hydride rechargeable batteries.
NOTE: These batteries cannot be charged with this product. Use the designated battery charger. Also, for details regarding
use of rechargeable batteries, follow the directions accompanying them.
You will hear a beep as the batteries are installed.
NOTE: The beep will not sound if AC adaptor is connected.
Close the battery compartment cover.
Do not force the battery cover into position. Insert two tabs to the main unit rst, Fig.1 . Then
] at
AA (LR6)
BATTERIES
close the cover, pressing [ section Fig.2 . lose the cover completely Fig.3 .
1)
two tabs
2 ADJUST DATE AND TIME AND ACTIVATE THE CLOCK
Touch S T K and keep your nger on the
key until 20 11 starts ashing.
Clock is set in the order of year, month, day,
hour and minute.
The ashing number increases with
KEY [1] and decreases with KEY [2]. The
number will be fast-forwarded if you keep your
nger on the key. Touching S T key will
number and the ne t article will ash. Touching
"START/STOP" key will terminate the setting.
As the date and time are set, clock is activated.
Display of the clock while the device is turned
off indicates that the clock is activated.
-7-
2) 3)
PRESS
Keep your finger
on the key.
the
1
con rm increase
click!
2
decrease