Nissei DSK-1011 Bedienungsanleitung Seite 8

OPERATION WITH AC ADAPTOR
AC CONNECTOR is located at the side of the
monitor.
Use the designated AC adaptor only.
It is suggested to take out the batteries when using the adapter. However, the clock is
inactivated as the AC adaptor is unplugged and therefore you may insert the batteries to
M A K I N G A M E A S U R E M E N T
Insert AIR PLUG into AIR CONNECTOR before
starting a blood pressure measurement.
The cuff is applicable to
circumference between 22 and 32 cm. Take
your arm size before measurement.
Choose your memory bank before measurement
to use the personal mode effectively.
Inaccurate readings may
result if cuff is wrapped
over heavy clothing or tight
shirt that may restrict
circulation in your upper
arm or if sleeve is rolled up.
AC CONNECTOR
AIR
CONNECTOR
arm with
keep the clock activated. In such case, please make a few measurement without
plugging the adaptor to avoid battery leak.
Do not connect the AC adaptor to any power socket where accessibility is not satisfying.
Protection: This device is double insulated and protected against short circuit and
overload by a primary thermal fuse.
Enclosures and Protective Covers: Equipment enclosed to protect against contact
with live parts, and with parts which can become live (finger, pin, hook test).
1
SIT ON A CHAIR AND APPLY CUFF.
Find a chair and a table so that you can be comfortably seated with your feet flat on the
floor and your back and arm supported.
Put the cuff on your left arm with
AIR HOSE positioned toward your
hand.
-8-
hook and loop
fastener