Philips SCD 469 Bedienungsanleitung Seite 16

EngliSh
16
Question
Why do the power light and
the SYSTEM CHECK light of
the parent unit not go on
when I turn the VOLUME
control to switch on the
parent unit?
I try to use the parent unit
on mains power, but the
power light and SYSTEM
CHECK light do not go on
when I place the parent unit
in the charger. Why?
Why does the parent unit
beep?
Why does the SYSTEM
CHECK light on the parent
unit blink red?
Why does the battery pack
of the parent unit not
charge?
Answer
The volume has been set too high. Set the volume to a lower
level.
The battery pack is low. Recharge the battery pack.
The battery pack has reached the end of its life. Replace the
battery pack.
Perhaps you forgot to plug in the charger. In that case, plug in the
charger. If the battery pack is entirely empty, you have to charge it
for 20 minutes before you can run the parent unit from the mains.
This signifies that the units are out of range from each other. Place
the parent unit closer to the baby unit.
The batteries of the baby unit may be low. Replace the batteries.
The battery pack of the parent unit is low. Recharge the battery
pack.
The parent unit cannot establish connection with the baby unit
even though it is close to the baby unit. Reset the baby unit.
The baby unit is not switched on. Press the POWER button on
the baby unit to switch it on.
This signifies that the units are out of range from each other. Place
the parent unit closer to the baby unit.
The batteries of the baby unit are low. Replace the batteries.
The battery pack of the parent unit is low. Recharge the battery
pack. If recharging does not help, replace the battery pack.
The parent unit cannot establish connection with the baby unit
even though it is close to the baby unit. Reset the baby unit.
The baby unit is not switched on. Press the POWER button on
the baby unit to switch it on.
Perhaps the charger is not plugged in properly. Insert the small
plug in the charger and insert the adapter in the wall socket.
If the battery pack fails to charge when the charger is plugged in
properly, the battery pack has reached the end of its life. Replace
the battery pack.