Remote Control - CO/Tech AH18CCR Bedienungsanleitung

7. If needed adjust the angle of the heater by loosening the connecting bracket's bolt.
Adjust to the desired angle and re-tighten the bolt when finished.

Remote Control

1. Open the battery cover on the back of the remote control
by sliding it down in the direction of the arrow.
2. Insert 2 × AAA/LR03 batteries.
Note: Note the polarity markings in the battery
compartment to ensure correct insertion.
3. Refit the battery cover.
Operating instructions
1. Plug the mains lead into an easily accessible (230 V, 50 Hz) wall socket.
2. Press the power switch to the I position to
put the heater into standby mode.
3. The LED indicator (c) will now flash,
indicating that the heater is now in
standby mode.
a. [ SELECT ] Turns the heater on and
returns it to standby mode.
b. IR sensor for receiving signals from
the remote control
c. LED indicator
a
5
b c