Technical Data; Before Use - Hilti AG 180-20 D Bedienungsanleitung

5 Technical data

Right of technical changes reserved.
When powered by a generator or transformer, the generator or transformer's power output must be at least twice the
rated input power shown on the rating plate of the power tool. The operating voltage of the transformer or generator
must always be within +5% and -15% of the rated voltage of the power tool.
Power tool
en
Rated power input
Rated current input
Rated frequency
Rated speed
Max. washer diameter
Weight in accordance with EPTA procedure 01/2003
Information about the power tool and its applications
Thread diameter
Thread length
Protection class as per EN / IEC
NOTE
The sound pressure and vibration values given in these instructions have been measured in accordance with a
standardized test and may be used to compare one electric tool with another. They may be used for a preliminary
assessment of exposure. The data given represents the main applications of the electric tool. However, if the electric
tool is used for different applications, with different accessories or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period. An accurate estimation of exposure should also take into
account the times when the tool is switched off, or when it is running but not actually being used for a job. This may
significantly reduce exposure over the total working period. Identify additional safety measures to protect the operator
from the effects of noise and/or vibration, for example: maintain the electric tool and accessories, keep the hands
warm, organisation of work patterns.
Noise and vibration information (measured in accordance with EN 60745‑2‑3 ):
Typical A-weighted sound power level, L
Typical A-weighted emission sound pressure level, L
Uncertainty for the given sound level, K
Uncertainty (K)
Triaxial vibration values
Surface grinding with the vibration absorbing side
handle, a
h,AG
Uncertainty (K)
Additional information

6 Before use

CAUTION
Wear gloves when fitting or removing parts, when
making adjustments or when remedying malfunc-
tions.
18
AG 180‑20D/ AG 180‑20P
220...240 V: 2,000 W
8...9 A
50 / 60 Hz
8,500/min
Ø 180 mm
5.2 kg
M14
15 mm
Protection class II (double insulated)
108 dB (A)
WA
97 dB (A)
pA
3 dB (A)
1.5 m/s²
6.15 m/s²
1.5 m/s²
Other applications may produce vibration values that
deviate from the given values.
6.1 Fitting the side handle
Screw the side handle into one of the threaded bushings
provided.