Description; Consumables - Hilti AG 180-20 D Bedienungsanleitung

3 Description

3.1 Use of the product as directed
The power tool is designed for cutting and grinding metals
and mineral materials.
The power tool may be used only for dry cutting or
grinding.
The power tool may be operated only when connected
to a power supply providing a voltage and frequency
in compliance with the information given on its type
identification plate.
Working with metals:
fiber-reinforced grinding or cutting discs.
Working with mineral materials: Cutting, slitting and
grinding.
Use only discs (abrasive grinding discs, abrasive cutting
discs, etc.) that are approved for use at a speed of at
least 8500/min, with a maximum thickness of 6.4 mm
(grinding discs) or 2.5 mm (cutting discs) and a diameter
of max.180 mm.
Observe the national health and safety requirements.
To avoid the risk of injury, use only genuine Hilti ac-
cessories and insert tools.
The power tool is designed for professional use and may
be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of
any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards
when used incorrectly by untrained personnel or when
used not as directed.

4 Consumables

NOTE
Accessories can be found at your Hilti Center or online at www.hilti.com.
Discs with a diameter of max. 180 mm, designed for a speed of 8500/min and a peripheral speed of 80 m/sec,
and with a maximum thickness of 6.4 mm (abrasive grinding discs) or 2.5 mm (abrasive cutting discs).
Discs
Abrasive cutting disc
Diamond cutting disc
Abrasive grinding disc
Diamond grinding disc
Assignment of discs to the equipment used
Equipment AC‑D
-
Guard
Guard with cover X
plate
Side handle X
Clamping nut X
Clamping flange X
Synthetic resin-bonded,
Application
Cutting, slitting
Cutting, slitting
Rough grinding
Rough grinding
AG-D
X
-
X
X
X
3.2 Items supplied as standard include:
1 Power tool
1 Guard
1 Side handle
1 Clamping flange
1 Clamping nut
1 Wrench
1 Operating instructions
3.3 Starting current limitation
The electronic starting current limiter reduces the starting
current drawn by the power tool and thus prevents the
mains fuse blowing. It also allows the power tool to start
smoothly, without a jolt.
3.4 Restart interlock (AG 180‑20P)
The power tool does not restart by itself when the switch
remains pressed or is locked and the power returns after
an interruption in the electric supply. The switch must
first be released and then pressed again to restart.
3.5 Guard with cover plate 2
DANGER
When using abrasive cutting discs to cut or slit metals,
the guard with cover plate must be fitted. When using
diamond cutting discs it is recommended that the
guard with cover plate is fitted.
Designation
AC‑D
DC‑D
AG‑D, AF‑D, AN‑D
DG‑CW
AF-D AN-D
X X
- -
X X
X X
X X
Material
metal
mineral
metal
mineral
DG‑CW DC‑D
-
X
-
X
X X
X X
X X
en
17