D) Mains Voltage Output; E) Operation - VOLTCRAFT SLS-150-12 Bedienungsanleitung

d) Mains voltage output

• Do not pull the mains plug from the mains socket of the inverter by pulling the
cable.
• Never connect the 230 v output of the inverter to another 230 v source (e.g.
a mains socket). The inverter must not be used to feed mains voltage into an
electrical building installation.

e) Operation

• Do not operate the inverter unsupervised.
• Even after triggering the internal protective device, parts of the inverter may still
be live!
• The housing of the inverter will heat up in operation (depending on the output).
Therefore, always observe sufficient ventilation of the inverter; never cover it in
operation. Never close the ventilation slots of the inverter.
Keep a minimum distance of 5 cm from other devices around the housing of the
inverter.
• Never operate the inverter immediately after it has been taken from a cold room
to a warm room. The resulting condensation may lead to malfunctions or dam-
age! Moreover, there is the risk of a fatal electric shock!
Let the inverter reach room temperature before connecting and operating it. This
may take several hours!
• Only operate the inverter in a moderate climate, never in a tropical climate.
For more information on acceptable environmental conditions, see the chapter
"Technical data".
• Never overload the inverter. In spite of comprehensive protective circuits, a defect
or damage to the inverter or the connected devices cannot be fully excluded.
29