Close the cover of the fresh water res-
ervoir.
Insert the fresh water container into the
appliance.
Replace the battery
Figure 5, see cover page
Press the release and pull the depleted
battery out of the battery compartment.
Figure 3, see cover page
Insert the charged batteries into the bat-
tery compartment and push in until they
lock into place.
Transport
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
Swivel the appliance handle forward
and arrest in the park position.
Swivel the pushing handle backwards
and push the appliance.
or
Lift appliance by the carrying handle
and carry it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.
This appliance must only be stored in inte-
rior rooms.
Care and maintenance
WARNING
Risk of injury if the machine is left running
in an unattended state.
Turn the appliance off before carrying out
any tasks on the machine.
ATTENTION
Risk of damage to the device on account of
water leakage. Empty the waste water tank
and the fresh water tank prior to performing
maintenance tasks on the device.
14
Storage
Maintenance schedule
After the work
ATTENTION
Risk of damage. Do not sluice the appli-
ance with water and do not use aggressive
detergents.
Empty the waste water tank.
Clean the seals between the waste wa-
ter tank and the appliance.
Empty the fresh water reservoir.
Rinse the appliance: Fill the fresh water
reservoir with clear water (without de-
tergent) and let the appliance run for
one minute with the brush water supply
turned on.
Empty the fresh water reservoir.
Clean the outside of the appliance with
a damp cloth which has been soaked in
mild detergent.
Clean the vacuum bar, check for wear
and replace if required (see "Mainte-
nance tasks").
Check the brush for wear and replace if
required (see "Maintenance tasks").
Yearly
Have the prescribed safety inspection
carried out by an electrician.
Maintenance Works
Replace the vacuum bar.
Note:
The vacuum bars are attached to the appli-
ance with snaps and can simply be pulled
off.
Move the suction bar lift pedal to posi-
tion „suction off" (Fig. 4 - position "1/
ON", see inside front cover).
Remove the fresh water reservoir.
Remove the waste water tank.
Lay the device on the reverse.
Pull off the vacuum bar downwards.
Insert the new vacuum bars and lock
them into place.
– 4
EN