Insert The Batteries; Complete Cleaning - Kärcher BR 30/4 C Bp Bedienungsanleitung

 Remove the fresh water reservoir from
the appliance.
 Open the cover of the fresh water reser-
voir.
 Pour in water/detergent mixture. Maxi-
mum temperature of the liquid 50 °C.
 Close the cover of the fresh water res-
ervoir.
 Insert the fresh water container into the
appliance.

Insert the batteries

Figure 3, see cover page
 Insert the batteries into the battery com-
partment and push in until they lock into
place.
Cleaning
ATTENTION
Risk of damage to the floor covering. The
cleaning method for heavy soiling must
only be used on floors suitable for this kind
of cleaning.
Risk of damage to the fresh water pump if it
runs dry because of empty fresh water
tank. Monitor the filling level display and
switch the water pump switch off if the fresh
water tank is empty.
Normal soiling
 Move the suction bar lift pedal to posi-
tion „suction off" (Fig. 4 - position "1/
ON", see inside front cover).
 Press the park position release and
swivel the handle toward the rear.
 Press the switch for brushing/vacuum-
ing operation.
 Activate the water pump switch.
 Move the appliance over the surface to
be cleaned.
Severe soiling
ATTENTION
Risk of damage to the floor covering. The
cleaning method for heavy soiling must
only be used on floors suitable for this kind
of cleaning.
 Move the vacuum bar lift pedal to posi-
tion „do not suction off" (Fig. 4 - position
"0/OFF" see inside front cover) and per-
form the cleaning as you would with
normal soiling. The detergent liquid re-
mains on the surface to be cleaned and
has time to settle in.
 Move the vacuum bar lift pedal to posi-
tion "suction off" and reclean the sur-
face.

Complete cleaning

 Turn off the water pump switch.
 Push the appliance a little further to
vacuum up the remaining water.
 Press the switch for brushing/vacuum-
ing operation.
 Swivel the appliance handle forward
and arrest in the park position.
Emptying the waste Water tank
Note:
If the waste water tank is full, the float clos-
es the suction channel. The suction opera-
tion is interrupted. Empty the waste water
tank.
WARNING
Please observe the local provisions regard-
ing the wastewater treatment.
 Turn off the appliance.
 Position the appliance upright and ar-
rest it in the park position.
 Remove the fresh water reservoir from
the appliance.
 Swivel support bow downward and re-
move the waste water tank.
 Lift the lock and remove the lid of the
waste water tank.
 Pour out dirt water.
 The rinse the dirt water reservoir with
clear water.
 Replace the lid of the waste water tank
and lock it.
 Insert the waste water tank into the ap-
pliance.
Emptying the Fresh Water Reservoir
 Remove the fresh water reservoir from
the appliance.
 Open the cover of the fresh water reser-
voir.
 Pour out the cleaning liquid.
– 3
EN 13