Troubleshooting; Technical Specification - VOLTCRAFT 20 15 40 Bedienungsanleitung

TROUBLESHOOTING

Status Potential cause
Charger will not start. No mains voltage.
Device overheats and
switches off.
Intermittent contact at the
terminals.
Output short-circuited.
Charging not stable. DIP switch settings do not
match battery type.
Battery is not charged Battery data do not match
through to Phase 4. the technical specification
of the device.
Battery is defective.

TECHNICAL SPECIFICATION

Input voltage .........................................200-240 V/AC, 50/60 Hz
Primary charge, bulk/absorption ...........12 V-Version: 14,2 V / 14,6 V / 14,8 V
Primary charge, float ............................12 V-Version: 13,2 V / 13,5 V / 13,8 V
Output ripple .........................................< 50 mA at full load
Efficiency up to .....................................87 %
Load equalisation .................................1.5 % of output current: no load ~ at full load
Operating temperature .........................0 - 40 °C
Insulated battery connections ...............2
Ventilation .............................................Cooling fan
Item no. 201540
Max. charge current 15 A
Max. battery capacity 30-200 Ah 40-300 Ah 50-600 Ah 20-150 Ah 25-300 Ah
Width (ca.) 200 mm
Length (ca.) 215 mm
Height (ca.) 80 mm
Weight (ca.) 1,7 kg
Remedy
Check the mains voltage supply.
Allow the device to cool down.
Check connections between
charger and battery.
Set DIP switches for battery type.
Battery cannot be charged using
the device.
Dispose of the battery.
24 V-Version: 28,4 V / 29,2 V / 29,6 V
24 V-Version: 26,4 V / 27,0 V / 27,6 V
201541 201542 201543
30 A 40 A 10 A
240 mm 240 mm 200 mm
235 mm 235 mm 215 mm
80 mm 80 mm 80 mm
2,5 kg 2,8 kg 1,9 kg
201544
20 A
240 mm
235 mm
80 mm
2,8 kg
( Legal notice
These operating instructions are a publication by Voltcraft®, Lindenweg 15, D-92242 Hirschau/Germany,
Phone +49 180/586 582 7 (www.voltcraft.de).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment
reserved.
© Copyright 2010 by Voltcraft®.