Troubleshooting; Technical Specifications - Schaub Lorenz MC1200 Bedienungsanleitung

TROUBLE SHOOTING
If a fault occurs, first check the points listed below before taking the unit for repair.
If you are unable to solve a problem by following these tips, consult your dealer or authorized service
center.
WARNING: Under no circumstances should you try to repair the unit yourself.
PROBLEM
General
No sound
No button function
RADIO
Poor reception
CD/MP3
The CD is skipping
or NO DISC is
displayed.

TECHNICAL SPECIFICATIONS

General
Power supply
Back-up and station memory:
Remote control
Power consumption
Radio
Frequency range
Antenna
Dimensions
Weight
Subject to change without prior notice.
36. GB
POSSIBLE CAUSE
Volume is set too low.
Headphones are connected.
Batteries exhausted.
Batteries inserted incorrectly.
Mains cable not connected.
Electrostatic discharge.
Weak signal
Interferences by other appliances (TV sets,
VCRs, computers, etc.).
The CD/MP3 is damaged or dirty.
AC230V ~ , 50Hz
DC 3V
(not supplied)
DC 3V
28W
FM: 87.5MHz-108MHz
AM: 525kHz-1615kHz
FM: wire antenna
AM: built-in ferrite antenna
approx. 34 x 17 x 22 cm (radio/player with stand)
approx. 13 x 16 x 22 cm (speaker with stand)
approx. 4.2 kg
SOLUTION
Adjust the volume.
Disconnect the headphones.
Insert new batteries.
Observe polarity.
Connect mains cable correctly.
Disconnect mains cable for some
seconds und reconnect.
Adjust the antenna:
FM: Wire antenna.
AM: Adjust the device.
Keep distance to other appliances.
Replace or clean the disc.
2 x UM-3/AA /LR6, 1.5V batteries
1 x CR2025 battery