Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. The mark on the stand at the rear of the unit must snap in place and line up with the lock icon.
(To remove slide the stand downward.)
Wall Mounting
Main unit and speakers come with 2 keyhole brackets each at the rear. Drill 2 x 6mm ø holes for each in
the correct distance and insert wall plugs. Screw 6 fillister head screws (3.5 x 25mm) into the wall plugs
and leave them stand out a few millimeters. A drilling template, wall plugs and screws are supplied.
Hang up unit and speakers on the screws.
Please observe not to damage hidden cables and pipes during drilling.
Back-up Batteries for Clock
Insert 2 x UM-3, 1.5V batteries (not supplied).
Open the battery compartment at the rear, insert the two batteries observing the correct polarity and
close the battery compartment again. This helps bridge short power failures and keeps your current time
and timer settings.
Basic Operation
Remote Control
All system functions can be controlled with the remote control. Many of the functions can be controlled
with the push buttons on the front panel of the system.
On/Off
Switch the unit off with the
Press the
ON/STANDBY button on the unit or on the remote control to switch the unit on;
displayed and the system is ready for use.
Select the mode with FUNC. on the remote control or FUNCTION on the unit, press repeatedly to cycle
through the modes TUNER, AUX, USB, CARD and CD.
Set the unit back into standby mode by pressing ON/STANDBY button on the unit or on the remote
control when not in use,
When turned on from standby mode, the unit turns on in the previous mode.
Electronic Volume Control
Press or press and hold VOL UP
increase or decrease the volume level between VOL 00 and VOL 30. The volume level is displayed as a
VOLUME bar.
Press and hold VOL UP
decrease the volume. At the desired level release the corresponding button again.
Briefly press the buttons to increase or decrease the volume level one step at a time.
Mute
Press MUTE (only on the remote control) to mute the sound. The volume bar on the display flashes.
Press MUTE on remote control again or press VOL UP
remote control to unmute the sound.
28.
GB
CLICK
ON/STANDBY button on the unit or on the remote control when not in use.
is displayed.
or VOL DOWN
or VOL DOWN
on the unit or VOL+/- on the remote control to increase or
Indicator mark
The stand is
properly
installed if the
markings on
stand and lock
icon line up.
Lock symbol
on the unit or VOL+/- on the remote control to
or VOL DOWN
on the unit or VOL+/- on the
is
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
