Emptying The Grass-Catcher; End Of Work - EMAK ELV63 Gebrauchsanweisung

WARNING!
When cutting on sloping ground, the
forward speed must be reduced to ensure safe condi-
tions ( 1.2 - 5.5).
– Lower the speed whenever you note a reduction in engine
speed, since a forward speed that is too fast compared to
the amount of grass being cut will never mow the grass
well.
– Disengage the blade and put the cutting deck in the highest
position whenever you need to get past an obstacle or a
hump.
EL63 model
– Use the 3rd gear only when moving the machine from
one area to the other.
ELV63 model
– Only use maximum speed when moving the machine
from one area to the other.

5.4.6 Emptying the grass-catcher

The grass-catcher is full when the
grass cuttings remain on the lawn.
If you continue mowing with the
grass-catcher full, it may block the
collector channel.
To empty the grass-catcher:
1. lower the engine speed;
2. go into neutral (N) ( 4.4a or
4.4b) and stop the machine's
forward movement;
EN 22
3. disengage the blade (
4. engage the parking brake on slopes;
5. hold onto the rear handle and tip up the grass-catcher to
empty it;
NOTE
This operation can only be done with the
blade disengaged, otherwise the engine stops.
5.4.7 Unblocking the collector channel
WARNING!
This job must only be performed with
the engine turned off.
If the collector channel gets blocked (due to accumulated
grass cuttings filling up the grass-catcher or an excessively
high speed with relation to the quantity of grass cuttings), you
need to:
1. stop forward movement immediately, disengage the blade
and stop the engine;
2. remove the grass-catcher;
3. remove the accumulated cuttings, reaching them from the
exit of the collector channel.
5.4.8 End of mowing
When you have finished mowing, disengage the blade, lower
the engine speed and ride the machine with the cutting deck
in the highest position.

5.4.9 End of work

Once you have finished mowing, stop the machine and
engage the parking brake.
4.6);