EMAK ELV63 Gebrauchsanweisung Seite 94

NOTE
When moving the machine, the blade
must be disengaged and the cutting deck put at its highest
position (position «5»).
To start the forward movement:
1. put the accelerator control between the «SLOW» and
«FAST» positions;
EL63 model
2. push the pedal right down (
change lever in 1st gear (
3. release the pedal gradually to begin the movement.
Reach the desired operating speed using the accelerator
and gear lever. To change gear, the clutch must always be
used by pushing the pedal (
WARNING!
The pedal must be released gradu-
ally as sudden engagement may cause tipping up and
loss of control of the vehicle.
ELV63 model
2. make sure the speed gear shift (
3. push the pedal ( 4.2) to the floor to release the park-
ing brake;
4. then gradually release the pedal;
5. before fully releasing the pedal, move the speed gear
shift towards «F» to start forward movement;
6. when the machine starts to move, fully release the pedal
EN 20
4.2) and put the gear
4.4a).
4.2).
4.4b) is in idle «N»;
and reach the desired speed by using the speed gear
shift and accelerator.
WARNING!
Do not suddenly release the pedal
and do not start moving with the gear shift more than
1/3 of the way towards «F» to avoid suddenly engag-
ing drive which could cause the vehicle to tip and loss
of control.
5.4.3 Braking
To brake:
1. first slow down the machine by reducing the engine speed;
2. push the pedal right down (
more until the machine stops.
ELV63 model
3. Move the speed gear shift (
gradual motion.
5.4.4 Retromarcia
IMPORTANT
Reverse MUST be engaged only when
the machine has stopped.
EL63 model
1. When the machine has stopped, put it in reverse by
moving the lever sideways to position «R» (
2. gradually release the pedal to engage the clutch and
then begin moving in reverse.
4.2) to lower the speed even
4.4b) to idle «N» to permit
4.4a);