Grass Cutting - EMAK ELV63 Gebrauchsanweisung

ELV63 model
1. Stop the machine, and push the pedal half-way to the
floor ( 4.2);
2. then gradually release the pedal;
3. before fully releasing the pedal, move the speed gear
shift ( 4.4.b) towards «R» to start reverse movement;
4. when the machine starts to move, fully release the pedal.

5.4.5 Grass cutting

IMPORTANT
The machine is not designed for heavy-
duty use or for mowing large quantities of grass.
IMPORTANT
The blade is engaged by means of a
clutch device. To avoid damage or premature wear of the
friction elements, strictly observe the following instructions.
To start cutting:
1. remove any foreign objects that could be hit by the blade
(stones, branches, bones, wire etc.) and mark off the posi-
tion of hidden elements that cannot be moved (roots, sprin-
klers etc.);
2. check that the grass-catcher is fitted pro-
perly;
3. put the accelerator lever into the «FAST»
position;
4. bring the cutting deck to the highest position
before engaging the blade;
5. only engage the blade (
ing in the intermediate positions when on the
grass lawns. Avoid engaging the blade on
stony ground or when the grass is very high.
6. start moving forwards onto the grass area
very gradually and with particular caution, as already
described;
7. on rough ground, adjust the cutting height to prevent the
blade from knocking against uneven ground or foreign
objects, damaging the blade and bracket;
EL63 model
8. engage the most suitable gear in order to reach the
desired forward speed (1st - 2nd gear) and adjust the
cutting height ( 4.5) so that the quantity of grass to be
removed is not too much that it jams the blade or clogs
up the collector channel.
ELV63 model
8. Adjust forward speed (
( 4.5) so that the amount of grass to be removed is
not too much that it jams the blade or clogs the channel;
it is always best to start cutting at low speed and gradu-
ally increase to a maximum of about 2/3 of the gear shift
stroke.
4.6) without paus-
4.4b) and cutting height
EN 21