Troubleshooting; Technical Data - Cleanmaxx SLX225C Gebrauchsanleitung

Troubleshooting

If the device should stop working properly, fi rst check whether you are able to correct the
problem yourself. Otherwise, contact our customer service department.
Do not try to repair a faulty device yourself!
Problem
The device only works slowly
or does not start.
Low suction force.
Dust escapes from the
device during cleaning.
The control lamp does not
light up when the device
is connected to the mains
power.

Technical Data

Device
Model number:
Article number:
Voltage supply:
Motor power:
Battery charge time:
Battery operating time:
Mains adapter
Model number:
Voltage supply:
Output:
Protection class:
Possible cause / solution
• Is the battery fl at? Recharge it.
• Is the collecting container full? Empty it.
• Is the fi lter heavily clogged up? Clean it.
• Is the suction opening blocked?
Switch off the device and remove the blockage.
• It is also possible that some smaller items will
remain stuck to the carpet or are too big / heavy to
be picked up by the device. Remove these foreign
bodies by hand.
• Check whether the collecting container and fi lter
are inserted correctly and adjust the fi tting if
necessary.
• Is the mains adapter plugged correctly into the
plug socket and is the barrel connector in the
connecting socket of the device?
• Is the plug socket defective? Try another plug
socket.
• Check the fuse of your mains connection.
SLX225C
Z 08862
5.5 V DC, 200 mA
30 W
approx. 8-12 hours
approx. 20 minutes (with fully charged battery)
TDUB-63I
230–240 V~ 50 Hz
5.5 V DC, 200 mA
II
22