Yamaha PW45 Originalbetriebsanleitung Seite 54

76 - English
BATTERY PACK AND CHARGING PROCEDURE
Lock-release ring
Top of the case
Battery bottom
Key lock
Battery handle
6. See "Reading the charging status", and check that the
battery charger is charging the battery pack.
7. The battery capacity display lamps will light up one by
one until all four are on. Then, when charging is com-
plete, all of the lamps will go off.
8. Confirm that charging is complete, and then discon-
nect the charging plug from the battery pack.
How to disconnect the plug (see the left figure)
Grasp the lock-release ring.
Pull it out straight.
9. Place the cap on the battery pack's charging connec-
tor.
10. Mount the battery pack on the bicycle.
TIP
Mounting method of the battery pack
• Insert the battery in the direction of the arrow so that
the battery bottom is aligned to the top of the case.
• Insert the upper part of the battery in the direction of
the arrow so that the battery handle is aligned to the
top of the key lock.
• Press the upper part of the battery toward the frame
until it clicks into place to secure it.
25
BATTERY PACK AND CHARGING PROCEDURE
11. Make sure that it is securely attached by pulling the
Make sure there is no foreign matter on the battery
pack contacts before inserting the battery pack.
battery after installation.
26
English - 77