Instrument And Control Functions; Display Unit - Yamaha PW45 Originalbetriebsanleitung

62 - English

INSTRUMENT AND CONTROL FUNCTIONS

Display unit

Power switch
Assist mode
switch (up)
Assist mode Function select
switch (down) switch
Running assist
Running assist switch
indicator
Function
display
USB receptacle
TIP
" " switch does not function.
Assist power meter
Speedometer
Clock
Assist mode
indicator
Battery capacity indicator
11
INSTRUMENT AND CONTROL FUNCTIONS
Display unit
The display unit offers the following operations and infor-
mation displays.
2 Battery
Check if the rated battery (CR2032) is installed in the rear
Cover
Close of the display.
Waterproof If a battery is not installed, or if there is not sufficient bat-
seal
tery power remaining, install a new battery.
Battery
To adjust the time and set the units for distance and
speed, see "Clock and km/mile settings".
TIP
• Make sure that the waterproof seal is installed correct-
• Please use a new type CR2032 button cell battery (sold
2 Mounting and removing the display
To mount the display, press the lever on the holder while
Display
sliding the display towards the rear of the bicycle into the
holder. To remove the display, press the lever while sliding
the display towards the front of the bicycle out of the holder.
Holder
Lever TIP
• Adjust the display angle by loosening the display angle
• Make sure the display is turned off before mounting or
Display angle
adjust bolt
ly.
separately).
adjust bolt. The angle depends on each rider.
removing it.
12
English - 63