Yamaha PW45 Originalbetriebsanleitung Seite 50

68 - English
INSTRUMENT AND CONTROL FUNCTIONS
7 Remaining assist distance
This displays an estimate of the distance (in kilometers or
miles) that can be ridden with assist on the residual bat-
tery capacity of the battery installed. If you switch the as-
sist mode when the remaining assist distance is displayed,
the estimate of the distance that can be ridden with assist
changes.
The remaining assist distance estimate cannot be reset.
TIP
7 Battery capacity (%)
This displays the power remaining in the battery.
The residual battery capacity display cannot be reset.
7 Cadence
This displays your pedaling speed in revolutions per min-
ute.
The pedaling cadence display cannot be reset.
TIP
If you pedal in backward, "0.0" is displayed.
2 Running assist
When you are on or off the bicycle and start moving it, you
can use running assist without pedaling the bicycle.
When you press the running assist switch once, the run-
ning assist indicator will come on for five seconds.
Press and hold the running assist switch again while the
indicator is still lit.
Running assist will stop in the following situations:
• The remaining assist distance changes depending on
the riding situation (hills, headwind, etc.) and as the
battery runs down.
• If in "Off mode", "- - - -" is displayed.
• When you release the running assist switch.
• If you press another switch at the same time.
• When you start to pedal.
• If your bicycle speed exceeds the preset speed.
• If you select Off mode.
• If the wheels are not turning (when braking or coming
into contact with an obstacle, etc.).
17
INSTRUMENT AND CONTROL FUNCTIONS
TIP
The maximum speed will vary depending on the selected
gear. The maximum speed will become slower in a lower
gear.
Even if you release the running assist switch while the
function is being used, the running assist indicator will re-
main on the display for five seconds.
When you press and hold the running assist switch again
while the indicator is lit, the running assist function will be
available.
2 Clock and km/mile settings
Use the following steps to set the time and km/mile settings.
1. Make sure that the display is mounted on the display
2. Press the power switch while holding the function se-
3. When the "hour" on the clock begins to flash, release
4. Use the assist mode switches (up & down) to set the
5. Press the function select switch, and the "minutes" on
6. Use the assist mode switches (up & down) to set the
holder, and that the display unit is turned off.
lect switch.
the switches.
"hour".
the clock will begin to flash.
"hour".
18
English - 69