Yamaha PW45 Originalbetriebsanleitung Seite 53

74 - English
BATTERY PACK AND CHARGING PROCEDURE
If a charging fault occurs during charging, remove the
power plug of the battery charger from the socket and
wait for the battery pack/battery charger to cool.
[CHARGING THE BATTERY PACK MOUNTED ON THE
BICYCLE]
1. Connect the power plug of the battery charger to a
2. Remove the cap of charging inlet from the charging
3. See "Reading the charging status", and check that the
Lock-release ring
4. The battery capacity indicator lamps will light up one by
5. Confirm that charging is complete, and then disconnect
6. Place the cap of charging inlet on the battery pack's
Never handle the power plug, charging plug or touch
the charger contacts with wet hands. This could result
in electric shock.
household power outlet.
connector on the battery pack, and connect it to the
charging plug on the battery charger.
• Do not connect the charging plug of the battery
charger with the charging connector of the battery
in a wet state.
• Be sure to connect the charging plug only after the
charging connector on the battery pack is com-
pletely dry.
Otherwise the battery charger and battery may mal-
function.
• Do not apply excessive force to the charging plug
or pull on the cord with the charging plug connect-
ed to the battery.
Otherwise, the plug or connector may be damaged.
battery charger is charging the battery pack.
one until all four are on. Then, when charging is com-
plete, all of the lamps will go off.
the charging plug from the battery pack.
How to disconnect the plug (see the left figure)
Grasp the lock-release ring.
Pull it out straight.
charging connector.
23
BATTERY PACK AND CHARGING PROCEDURE
TIP
• Charging will start automatically.
• If the display unit is turned on while the battery pack is
• When the battery pack is connected to the battery
[CHARGING THE BATTERY PACK REMOVED FROM
THE BICYCLE]
1. Turn the display unit off.
2. Insert the key into the battery lock, and turn it clockwise
3. Remove the battery pack.
Use both hands when removing the battery pack, be-
ing careful not to drop it. Dropping the battery pack
on your foot could result in injury.
4. Connect the power plug of the battery charger to a
5. Remove the cap from the charging connector on the
• Do not connect the charging plug of the battery
• Be sure to connect the charging plug only after the
Otherwise the battery charger and battery may mal-
function.
• Do not apply excessive force to the charging plug
Otherwise, the plug or connector may be damaged.
charging, all normal displays will be shown, including
the battery capacity indicator, but the assist system will
not function.
charger, battery charger lamp will flash at approximate-
ly 0.2 second intervals to indicate that charging is pre-
paring to charge the battery pack. Leave it as it is and
charging will start normally.
to release the battery lock.
household power outlet.
battery pack, and connect it to the charging plug on the
battery charger.
charger with the charging connector of the battery
in a wet state.
charging connector on the battery pack is com-
pletely dry.
or pull on the cord with the charging plug connect-
ed to the battery.
24
English - 75