Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
Switch on the device. The display indicates the last operating mode. The operating modes can be selected
by means of the display and the control buttons. All settings remain stored even if the device is disconnected
from the mains. The device can be operated in stand-alone mode via the control board and the EUROLITE
IR-26 remote control or in DMX-controlled mode via any commercial DMX controller.
Menu structure
Mode
DMX operation
DMX channels
Automatic mode
Master/slave
Sound control
Behavior on loss of
DMX signal
Display illumination
Information
Test program
Stand-alone mode
Automatic mode
In automatic mode, 7 show programs are available that run at an adjustable speed.
1
Press the MENU button so many times until ShNd is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with the ENTER
button.
2
Press the MENU button so many times until SPEE is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from 1 (slow) to SP
100 (fast). Confirm with the ENTER button.
Sound control
Via the integrated microphone the unit can perfectly reproduce the show programs to the rhythm of the
music (sufficient bass provided).
1
Press the MENU button so many times until SoUn is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the on setting. Confirm with the ENTER button.
2
Press the MENU button so many times until SoSE is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to Adjust the microphone sensitivity to the volume of the music (0
= low, 100 = high).
Display
Addr
001-512
14CH
ChMd
2CH
Sh1
Sh2
Sh3
ShNd
Sh4
Sh5
Sh6
Sh7
SPEE
0-100
MASt
SLMD
SLAV
SoUn
ON
OFF
SoSE
0-100
Prom
NodM
BLAC
HoLd
LED
ON
OFF
Ver
V10
Test
22/28
Function
Start address
14 channels
2 channels
Show program 1: Derby
Show program 2: Strobe
Show program 3: Laser
Show program 4: Derby + Laser
Show program 5: Derby + Strobe
Show program 6: Laser + Strobe
Show program 7: Derby + Strobe + Laser
Program running speed slow > fast
Master mode
Slave mode
Sound control on/off
Microphone sensitivity low > high
Master mode
Blackout mode
Last correct DMX value is held
Display illumination on/off
Firmware version
Test of all effects
00112264, Version 1.0
Werbung
Inhaltsverzeichnis
