Kärcher HDS 6/10 C Bedienungsanleitung Seite 50

damage before operation each
time. Do not put the device into
operation with a damaged pow-
er supply cable. Have a dam-
aged power supply cable
replaced immediately by the au-
thorised customer service / qual-
ified electrician. Do not
damage the power supply and
extension cable by running over
it, crushing or yanking it or simi-
lar. Protect the power supply ca-
ble from heat, oil and sharp
edges. Only use the mains
connection cable prescribed by
the manufacturer, including
when replacing the cable. For
order no. and type see operating
instructions. Unsuitable electri-
cal extension cables can be
dangerous. Only use approved
and appropriately marked elec-
trical extension cables with a
sufficient cable cross section for
outdoors. Only replace cou-
plings on the power supply or
extension cable using those with
the same water density and the
same mechanical strength.
CAUTION In case of longer
breaks in operation and after
use, switch off the device at the
main switch / device switch and
pull the mains plug.
ATTENTION Switch-on proce-
dures will generate short-term
voltage drops. Unfavourable
mains conditions may cause
other devices to be impaired.
10
In case of a network imped-
ance of less than 0.15 ohms, no
malfunctions are to be expected.
Water connection
WARNING The device
must not be started up if the
high-pressure hose is damaged.
Replace a damaged high-pres-
sure hose at once. Only those
hoses and connections recom-
mended by the manufacturer
may be used. For order no. see
operating instructions. The
screw connections of all connec-
tion hoses must be leak-tight.
ATTENTION Observe the reg-
ulations at your water distribu-
tion company.
DANGER When using the
device in hazard zones (e.g. ser-
vice stations), adhere to the re-
spective safety regulations.
Operation in explosive atmos-
pheres is prohibited. Never
suction solvents, liquids contain-
ing solvents or undiluted acids.
This includes e.g. petrol, paint
thinner or heating oil. The spray
mist is highly flammable, explo-
sive and poisonous. Damaged
wheels / tyre valves are ex-
tremely dangerous. Damaged
wheels / tyre valves can be
damaged by the high-pressure
jet and explode. The first sign of
this is discolouration of the tyres.
Keep a spray distance of at least
English
Operation