Cocraft HB-125 Bedienungsanleitung Seite 7

Assembly
Warning: Plug the machine in only after completing all assembly and adjustment work and
having read the user manual, all warnings and safety instructions.
1. Mount the bench grinder onto a stable platform such as
workbench using the four mounting holes (11). Use screws or bolts
suitable for the supporting structure. Note: Steps 2–4 are to be
carried out to both sides of the bench grinder.
2. Attach the tool rest (8) to the grinding wheel shatter guard (3) using
the lock knob (9). The gap between the grinding wheel and the tool
rest should be set to a maximum of 2 mm.
3. Attach the spark guard/eye shield bracket (1) to the shatter
guard (3) using both the screws. The gap between
the grinding wheel and the spark guard should be set to
a maximum of 2 mm.
4. Attach the eye shield (6) to the spark guard. Set the eye shield to the desired angle and
tighten the screw so that the shield stays in place but can be swivelled up or down.
Operating instructions
Preparations
• Make sure that the grinding wheel can rotate freely before starting the machine.
• Adjust the eye shield so that you have a good view of the grinding operation.
• Check that the distance between the grinding wheel and the tool rest and between the grind
wheel and spark guard is 2 mm or less.
Warning: The grinding wheel will wear down and become smaller after use which is why this
check must always be made.
7