Herunterladen Inhalt Inhalt Diese Seite drucken

Klarstein 10028328 Anleitung Seite 40

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Caring for the Dishwasher
• The control panel can be cleaned by using a lightly dampened cloth and dry thoroughly.
• The exterior use a good appliance polish wax. Never use sharp objects, scouring pads or harsh cleaners on
any part of the dishwasher. To clean the edge around the door, you should use only a soft warm, damp cloth.
• To avoid penetration of water into the door lock and electrical components, do not use a spray cleaner of
any kind.
Protect against Freezing
please take frost protection measures on dishwasher in winter. Each time after washing cycles, please operate
as follows:
1. Cut off electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve. (Use a pan to catch the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to use up water in sump.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water che-
micals will clog the spray arm jets and bearings. Inspect the filters
for blocking after every time the dishwasher has been used. By un-
screwing the coarse filter, you can remove the filter system. Remove
any food remnants and clean the filters under running water.
Remarks: The entire filter assembly should be cleaned once a week.
To remove the lower spray arm, pull out the spray arm upward. To
remove the upper spray arm, hold the nut, rotate the arm clockwise
to remove it. Wash the arms in soapy and warm water and use a soft
brush to clean the jets. Replace them after rinsing them thoroughly.
How to keep your Dishwasher in Shape
• After every wash, turn off the water supply to the appliance and leave the door slightly open so that mois-
ture and odors are not trapped inside.
• Before cleaning or performing maintenance, always remove the plug from the socket.
• To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products.
Only use a cloth with warm soapy water. To remove spots or stains from the surface of the interior, use a
cloth dampened with water with a little vinegar, or a cleaning product made specifically for dishwashers.
• It is recommend that you run a wash cycle with the dishwasher empty and then remove the plug from the
• socket, turn off the water supply and leave the door of the appliance slightly open. This will help the door
• seals to ast longer and prevent odours from forming within the appliance.
• If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary, it can be
• positioned on its back.
• One of the factors that cause odors to form in the dishwasher is food that remains trapped in the seals.
Periodic cleaning with a damp sponge will prevent this from occurring.
40

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis