Klarstein 10028328 Anleitung Seite 28

Loading the Salt into the Softener
• Only use salt specifically designed for use in dishwashers! All other types of salt not specifically designed
for use in a dishwasher, especially table salt, will damage the water softener. in case of damages caused by
the use of unsuitable salt the manufacturer does not give any warranty nor is liable for any caused damages.
• Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains
of salt or salty water, which may have been split, remaining of the bottom of the machine for any period of
time, which may cause corrosion.
How to load the Salt:
• Remove the basket and then unscrew and remove the cap from the salt container.
• Before first wash, add 1 lt. of water in the salt container of your machine.
• Place the end of the funnel (supplied) into the hole and introduce about 1kg of salt.
• After filling the container , screw the cap tightly back clockwise.
• Usually, the salt warning light will be cease to be illuminated within 2-6 days after the salt container has
been filled with salt. Immediately after filling the salt into the salt container, a washing programme should
be started Otherwise filter system, pump or other important parts of the machine may be damaged by salty
water. It is out of warranty.
NOTE: The salt container must only be refilled when the salt warning light in the control panel comes on. De-
pending on how fully the salt dissolves, the salt warning light may still be on even though the salt container is
filled. If there are spills of the salt, a soak or a rapid program should be run to remove the excess salt.
Fill the Rinse Aid Dsipenser
The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes. That can
leave spots and streaks. It also improves drying by allowing water to sheet off the dishes. Your dishwasher is
designed to use liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dis-
penser. To fill the dispenser, open the cap and pour the rinse aid into the dispenser until the level indicator turns
completely black. The volume of the rinse aid container is about 110ml. Rinse aid is automatically added during
the last rinse, ensuring thorough rinsing, and spot and streak free drying. Rinse aid is automatically added
during the last rinse, ensuring thorough rinsing, and spot and streak free drying. Only use branded rinse aid for
dishwasher. Never fill the rinse aid dispenser with any other substances (e.g. Dishwasher cleaning agent, liquid
detergent). This would damage the appliance.
28