Quick Reference Guide - Klarstein 10028328 Anleitung

1 Switch on the appliance
2 Fill the detergent
dispenser
3 Check the rinse aid level
4 Check the regeneration
salt level
5
Load the baskets
6 Select a programme
7 Running the dishwasher
8 Switch off the appliance
9
Turn off the water tap,
unload the baskets
Quick Operation Guide
Press the Power switch button to switch on the appliance, Open the door.
Big Compartment: with each wash cycle.
Small Compartment: for programmes with prewash only.
Check the rinse aid level panel (if provided).
If there is no salt warning light in the control panel (for some models), you
can estimate when to fill the salt into the softener by the number of cycles
the dishwasher has run.
Scrape off any large amount of leftover food. Soften remnants of burnt food
in pans, then load the baskets. Refer to the dishwasher loading instructions.
Close the door. Press the programme button until the selected programme
lights up. ( See the section entitled Operation instruction )
Turn on the water tap and press the Start/Pause button. The machine will
start working after about 10 seconds..
Changing the programme:
A running cycle can only be modified if it has been running for a short time.
Otherwise the detergent may have already been released. In this case, the
detergent dispenser must be refilled. dispenser must be refilled. Open
the door slightly ,then press the program button more than 3 seconds to
cancel the running programme. Select a new programme. Close the door,
restart the dishwasher.
Add forgotten dishes:
Open the door slightly, You can open the door completely until the spray
arms stop. Add the forgotten dishes. Close the door, the dishwasher will
start running again after 10 seconds.
If the appliance is switched off during a wash cycle:
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
dishwasher will sound 8 times, then stop. Turn off the appliance using the
Power button. Since the appliance is standing by, it will power off automa-
ticly after 30 minutes without any operation.
Warning: wait a few minutes (about 15 minutes) before unloading the dish-
washer to avoid handling the dishes and utensils while they are still hot and
more susceptible to break. They will also dry better.Unload the appliance,
starting from the lower basket.
38