Herunterladen Inhalt Inhalt Diese Seite drucken

Klarstein 10028328 Anleitung Seite 29

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Refill Rinse Aid Dispenser
If there is no rinse-aid warning light in the control panel, you can judge the
amount of rinse-aid by the color of the optical level indicator located next to
the cap. When the rinse-aid container is full, the whole indicator will be dark .As
the rinse-aid diminishes, the size of the dark dot decreases. You should never
let the rinse aid get below 1/4 full.
1. To open the dispenser, turn the cap to the „open" (left) arrow and lift it out.
2. Pour the rinse aid into the dispenser, being careful not to overfill.
3. Replace the cap by inserting it aligned with „open" arrow and turning it to the closed (right) arrow.
Clean up any rinse aid split during filling with an absorbent cloth to avoid excessive foaming during the next
wash. Don't forget to replace the cap before you close dishwasher door.
Adjusting Rinse Aid Dispenser
The rinse aid dispenser has six or four settings. Always start with the dispenser set
on „4". If spots and poor drying are problems, increase the amount of rinse aid dis-
pensed by removing the dispenser lid and rotating the dial to „5". If the dishes still
are not drying properly or are spotted, adjust the dial to the next higher number
until your dishes are spot-free. The recommended setting is „4". (Factory value is
„4".) Increase the dose if there are drops of water or lime spots on the dishes after
washing. Reduce it if there are sticky whitish stains on your dishes or a bluish film
on glassware or knife blades.
Function of Detergents
Detergents with its chemical ingredients are necessary to remove dirt, crush dirt and transport it out of the
dishwasher. Most of commercial quality detergents are suitable for this purpose.
Normally new pulverised detergent is without phosphate. The water softener function of phosphate is not
given. In this case we recommend to fill salt in the salt container even when the hardness of water is only 6
dH. If detergents without phosphate were used in case of hard water often white spots appear at dishes and
glasses. In this case please add more detergent to reach better results. Detergents without chlorine do only
bleach a little. Strong and coloured spots will not removed completely. In this case please choose a programme
with higher Temperature.
29

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis